Redline Tuning 2021+ Jeep Wrangler Rubicon 392 Hood QuickLIFT ELITE

Redline Tuning 2021+ Jeep Wrangler Rubicon 392 Hood QuickLIFT ELITE

$129.95
(No reviews yet) Write a Review
SKU:
21-20007-03
Adding to cart… The item has been added
Replace your hood's prop rod today with this Redline Tuning Hood QuickLIFT system. Progressive gas springs will lift and hold your hood without the need for a poorly placed prop-rod, simply start to lift your hood and let the QuickLIFT system take over. This design is entirely bolt-in and will take only a five minutes to install using only a 10mm socket. You'll use existing mounting locations on the These Systems include Quick-release end-fittings on the gas struts for the Jeep models. This allows the user to easily remove the strut from the lower attachment and then place the hood all the way back onto the wind-shield.
  • 5 MINUTE INSTALLATION - Very simple & quick installation
  • USES EXISTING MOUNTING LOCATIONS
  • TOOLS - 10mm socket and wrench, that's it!
  • QUICK-RELEASE - Rod ends have quick-release feature so that you can remove and lay the hood all the back against the windshield.
  • LIFTS & HOLDS HOOD without prop rod - just start to lift and let our Hood QuickLIFT System lift and hold up your hood.
  • MODIFICATIONS TO JEEP - For the 392 only, ECU bracket must be clearanced to allow room for our gas strut on passenger side. See installation manual for details.
FITMENT: The Jeep Wrangler Rubicon 392 Hood QuickLIFT ELITE system is designed to fit US OEM Jeep Wrangler Rubicon 392 models ONLY: 2021 2022+.

NOTE: If you have the Mojave Edition or a vehicle OUTSIDE North America, purchase 21-20006-03 system.
If you have any other 2018+ Wrangler or Gladiator inside U.S., purchase 21-20003-03. All of the mounting hardware is the same for the 2018+ Jeep models, but the gas struts are different based on the hood application.

Upper Mounting Bracket - Redline Tuning Lower Mounting Bracket - Redline Tuning Upper Mounting Bracket - Redline Tuning
Slip blind-insert into slot & align
the bracket vertically until you
can install lower bracket bolt. 		Tuck NVH felt liner behind bracket,
then tighten down bolts 		Bracket uses existing 10mm bolt,
rests on the fender lip for secure
support of gas strut.

QuickLIFT System weighs under 2 pounds
Prop rod can be removed once installed
Patent Pending Attachment System
Progressive, slow release gas springs - final few inches of operation, gas springs slow down extending rate allowing for a fluid lifting process.
Silver zinc-plated hardware in base QuickLIFT system
Black powder coated hardware in QuickLIFT PLUS and ELITE
316L Stainless steel gas springs in QuickLIFT ELITE
Full color installation manual with every QuickLIFT system
CAD designed hardware unique to each QuickLIFT application