Replace your hood's prop rod today with this Redline Tuning Hood QuickLIFT system. Progressive gas springs will lift and hold your hood without the need for a poorly placed prop-rod, simply start to lift your hood and let the QuickLIFT system take over. Our Jeep Gladiator Hood QuickLIFT system is simply the best on the market. This design is entirely bolt-in and will take only a five minutes to install using only a 10mm socket. You'll use existing mounting locations on the vehicle for the QuickLIFT system's lifting action.
This system includes Quick-release end-fittings on the gas struts. This allows the user to easily remove the strut from the lower attachment and then place the hood all the way back onto the wind-shield. Just snap strut back in place when done and the system sill then work as intended.
- 5 MINUTE INSTALLATION - Very simple & quick installation
- USES EXISTING MOUNTING LOCATIONS
- TOOLS - 10mm socket and wrench, that's it!
- QUICK-RELEASE - Rod ends have quick-release feature so that you can remove and lay the hood all the back against the windshield.
- LIFTS & HOLDS HOOD without prop rod - just start to lift and let our Hood QuickLIFT System lift and hold up your hood.
- MODIFICATIONS TO JEEP - For the 392 only, ECU bracket must be clearanced to allow room for our gas strut on passenger side. See installation manual for details.
FITMENT: This Jeep Wrangler Rubicon 392 Hood QuickLIFT PLUS system is designed to fit Jeep 2021+ Wrangler Rubicon 392 models ONLY: 2021 2022+.
If you have any Wrangler or Gladiator made for the North American market (excluding the Mojave), you need lower force gas springs for the lighter OEM Aluminum hoods. Purchase the 21-20003-02. If you have a Mojave edition or Wrangler/Gladiator purchased outside U.S., purchase 21-20006-02 systems that have been created specifically for those vehicles.
This system is the QuickLIFT PLUS system which includes all-black mounting hardware and black e-coated gas springs with progressive slow-release over final inches of extension. The ELITE series is exactly the same with the exception of the gas struts, swapped out for 316L Stainless steel.
 |  |  | ||||
| Slip blind-insert into slot & align the bracket vertically until you can install lower bracket bolt. | Tuck NVH felt liner behind bracket, then tighten down bolts | Bracket uses existing 10mm bolt, rests on the fender lip for secure support of gas strut. | |
Prop rod can be removed once installed
Patent Pending Attachment System
Progressive, slow release gas springs - final few inches of operation, gas springs slow down extending rate allowing for a fluid lifting process.
Silver zinc-plated hardware in base QuickLIFT system
Black powder coated hardware in QuickLIFT PLUS and ELITE
316L Stainless steel gas springs in QuickLIFT ELITE
Full color installation manual with every QuickLIFT system
CAD designed hardware unique to each QuickLIFT application
